NetApp NS0-173 Exam Practice Test Instant Access

Question 1

After you install a FlexPod infrastructure at a customer site, you need to migrate the existing Vmware virtual machines off the infrastructure that was used before FlexPod was installed.

Which VMware vSphere feature accomplishes this task?

AvMotion

BvSphere DRS

CVM Component Protection

DvSphere HA

Answer : A

Question 2

Which Cisco Nexus series switch supports NX-OS standalone mode or Application Centric Infrastructure (ACI) fabric mode?

ANexus 7000

BNexus 3000

CNexus 9000

DNexus 5000

Answer : C

Question 3

You are configuring Cisco UCS servers for FC SAN boot and want to perform zoning on your Cisco Nexus 5000 series switches.

In this scenario, which statement is correct?

AThe corresponding FC ports on your NetApp storage array must be configured in LACP mode.

BAn iSCSI license on the NetApp storage controller is required.

CSAN links are required between the Cisco Fabric Interconnects and the Nexus 5000 switches.

DFC zoning on the Nexus series switches is not supported; zoning can be done only on the Cisco Fabric Interconnects.

Answer : D

Question 4

You are asked to design a FlexPod solution that meets the minimum requirements and includes Application Centric Infrastructure (ACI).

Which three Cisco components are required in this scenario? (Choose three.)

ACisco UCS B-Series servers

BCisco Nexus 9000 Series switches

CCisco Nexus 2000 Series Fabric Extender

DCisco Nexus 3000 Series switches

ECisco UCS Series Fabric Interconnects

Answer : A, B, E

Question 5

A customer is planning to use a pair of MDS switches in a FlexPod design to host a few SAN workloads.

In this scenario, which two features should be enabled on the MDS switches for a successful configuration? (Choose two.)

ANPIV

BNPV

Cport-channel-trunk

Dfport-channel-trunk

Answer : A, C

Question 6

You are configuring high availability within the network layer of your FlexPod configuration.

In this scenario, what are two Cisco best practices for designing vPC on your Cisco 9000 Series switches?

(Choose two.)

APeer keep-alive connectivity between the switches should be established.

BA minimum of four 10GB Ethernet connections are required for vPC.

CThe vPC auto-recovery feature should be enabled.

DPort channels should be configured for LACP passive mode.

Answer : A, B

vPC also relies on the periodic keepalive messages to determine when one of the connected devices on the peer link fails.

vPC peer link -- The link used to synchronize states between the vPC peer devices. Both ends must be on 10- Gigabit Ethernet or 40-Gigabit Ethernet interfaces.

configuration/guide/b_Cisco_Nexus_9000_Series_NX-OS_Interfaces_Configuration_Guide/ b_Cisco_Nexus_9000_Series_NX-OS_Interfaces_Configuration_Guide_chapter_0111.html

Question 7

You are designing a FlexPod solution that requires 32 ports running at 40 Gbps.

To satisfy this requirement, which Cisco Fabric Interconnect should you deploy?

A6332-16UP

B6332

C6248UP

D6296UP

Answer : B

FI 6332 is a one-rack-unit (1RU) 40 Gigabit Ethernet, and FCoE switch offering up to 2.56 Tbps throughput and up to 32 ports. The switch has 32 40Gbps fixed Ethernet.

NetApp NS0-173 Cisco and NetApp FlexPod Design Specialist Exam Practice Test