Huawei H12-322 HCIP-WLAN-POEW Exam Practice Test Instant Access

Question 1

Which of the following is not a way to increase the range of coverage signal strength?

AAdjust the AP position

BReduce the transmit power

CAdjust the antenna angle

DIncrease the transmit power

Answer : B

Question 2

In the coverage area, only the area where the field strength is required is selected (B), and the area with the specified number of bandwidth requirements is selected (A), and there is no concern whether there is a signal. Area selection?

AKey coverage areas

BOrdinary coverage area

CBlind area

Answer : C

Question 3

The following APs for indoor placement scenarios have (AB), APs with indoor distribution scenarios have (C), and APs with outdoor coverage/bridge backhaul scenarios have?

AAP 6010DN

BAP 7110DN

CAP 6310SN

DAP 6510DN

Answer : D

Question 4

The following description of the steps for Layer 2 roaming is wrong?

AThe STA listens to each channel beacon and finds that AP2 satisfies the roaming condition and sends a probe request to AP2.

BAP2 responds by sending a response on channel 6 after receiving the request in channel 6 (the channel used by AP2)

CThe STA sends the 802.11 disassociation information to the AP1 through the channel 6 (the channel used by the AP2), and the association between the user and the AP1 is released.

DThe STA sends an association request to AP2 through channel 6, and AP2 responds with the association response to establish an association between the user and AP2.

Answer : C

Question 5

In general, which of the following obstacles has the greatest attenuation for the 2.4 GHz signal when the material is of the same thickness?

AMetal

BAsbestos

CWooden door

DColored glass

Answer : A

Question 6

Which of the following is the function of the WLAN Survey Pad?

AAP photo and antenna pre-installation location photo

BWi-Fi interference source search and annotation information function

CObstacle attenuation test and report generation

DRF signal collection and mapping of obstacles and obstacles

EAddition of switches and drawing of room components

FScale setting and floor property settings

Answer : A, B, C, E, F

Question 7

What is the correct description of the WLAN site survey for different typical scenarios?

AThe office surveys the main load-bearing columns and partitions to cover the impact. If it is an overall suspended ceiling, the AP should be considered as close to the maintenance port, if it is metal
Ceiling, you can choose to place the AP under the ceiling or wall mount

BIf the wall of the school classroom is made of reinforced concrete, the signal attenuation is large. It is best to measure the attenuation when surveying. The teaching building should pay attention to the weak electricity room.
Set

CThe ward inspection scene has high requirements for coverage field strength, roaming effect, and bandwidth requirements. At the same time, it is necessary to pay attention to the interference or disallow of medical equipment.
Area with Wi-Fi signal

DThe stadium has a complicated environment and difficult wiring. Therefore, the weak house and the wiring should be confirmed with the property. If the distance is too far, it may be considered.
Adding an external switch, the survey should focus on mutual interference and installation methods between APs.

Answer : A, B, D

Huawei H12-322 HCIP-WLAN-POEW V1.0 HCIP-WLAN-POEW Exam Practice Test