Dell EMC DEA-5TT1 Exam Practice Test Instant Access

Question 1

What accurately describes the comparison between stacking and VLT?

AVLT allows for more physical devices to appear as one virtual device than stacking does.

BStacked switches share a common control plane while VLT peers maintain their own control plane.

CStacked switches and VLT peers allow ''single pane of glass'' management by maintaining a single control plane.

DBoth VLT and stacking allow devices to use different versions of firmware provided that the switch family/ series is the same.

Answer : B

https://downloads.dell.com/manuals/common/dellemcnetworking_stacking_vs_vlt.pdf Introduction section

Question 2

Which route type is added to the routing table by a routing protocol?

ADefault route

BDynamic

CStatic

DDirectly connected

Answer : B

Question 3

In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

AForwarding

BBlocking

CLearning

DListening

Answer : C

Question 4

Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

AStore-and-forward

BFragment-free

CUnicast

DCut-through

Answer : D

Question 5

A network administrator wants to use a subnet that will only have two host addresses. Which subnet mask meets this requirement?

A255.255.255.248

B255.255.255.252

C255.255.255.254

D255.255.255.256

Answer : B

Question 6

What is the aggregated lanes' maximum speed rating for a QSFP28 transceiver?

A4 Gbps

B40 Gbps

C112 Gbps

D128 Gbps

Answer : C

Question 7

On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

AC9000 Series

BN-Series

CS-Series

DZ-Series

Answer : B

Dell EMC DEA-5TT1 Associate - Networking Version 1.0 Exam Practice Test